Click on the
miniature tool for
more info.
Millanyangle
2000
cutter
INSTRUCTION BOOKLET
CAUTION: Before changing or indexing
insert, be sure insert holder part of tool
is securely locked at any angle.
SETTING THE ANGLE OF THE TOOL The best way to set the tool at an angle or
change the insert is when the tool is in a
While setting the angle with tool in machine, fixed tool holder, or machine.
or fixed tool holder. Use thumb and fore
finger to hold insert at desired angle while When tightening insert screw first use long
tightening wrench with other hand. end of wrench. Holding wrench near its
center with thumb and fore finger tighten
When setting angle with tool in hand. screw as much as you can, at the same
Hold insert at desired angle with thumb while time, use thumb and fore finger of other
tightening wrench with other hand(figure 1). hand to hold insert and wiggle it into
position. Now you have set the insert.
You will notice that there is a small space
between bottom of insert and insert
holder. Now use short end of wrench to
finish tightening screw and to seat the
insert into its proper position(figure 2).
(Figure1) (figure 2)